we think about measurement
Correct installation guide for magnetic flowmeters
1-The pipe must be completely full.
2-Do not subject the equipment to magnetic fields.
3-The fluid to be measured must be conductive.
Do not manipulate the equipment from the electronics
The pipe must always be full of fluid
For a correct measurement, the pipe must be full.
The equipment must be installed on the thrust side of the pump (if present)
Installation near valves
Avoid excessive vibrations
Do not expose the equipment to magnetic fields
Installation after choking valve
Device Landline Connection
It is extremely IMPORTANT that the flowmeter is grounded with a cable greater than 4mm2 for its correct operation. A poor ground connection will cause an incorrect flow reading.